Using QNX Containers on the target

This section contains instructions for creating and running QNX Containers on the target. You can quickly navigate through the steps using the following table:
To: Go to:
Pull a QNX Container application image Accessing a QNX Container application image
Create a QNX Pod and checking its status Creating a QNX pod and checking its status
Create a QNX Container Creating a QNX Container and checking its status
Start a QNX Container and checking its status Starting a QNX Container and checking its logs
Execute a command inside a QNX Container Executing a command inside a QNX Container
Debug a QNX Container Debugging a QNX Container
Stop and remove a QNX Container Stopping and removing a QNX Container
Remove a QNX Pod and a QNX Container image Removing a QNX Pod and a QNX Container image

Using the qcmctl CLI Utility

The command line tool utility, qcmctl, provides a command and control interface to manage Pods and Containers directly on a target. The command hierarchy of qcmctl is organized into three sub-commands: image, pod, and container; refer to QNX Container Manager Client (qcmctl).

Page updated: